hola, soy novaticimo en esto, pero vi algo que me gusto y lo quiero hacer, pero no se como, si ustedes me pueden ayudar lo agradeceria mucho, vi que eran los siguientes materiales, y tambien la placa, pero en si no se como hacer el circuito, les pongo tambien un video de lo que quiero, gracias
Component
Type
Quantity
PIC Microcontroller
Pre-programmed 16F628 chip.
1
Chip Socket
18 pin
1
Circuit Board
Board for all components to be mounted on.
1
Terminal Block
24 positions
1
Fuse Holder
Solder in Fuse Clips
2
Fuse
1A
1
Diode
1N4401
1
12V Filter Capacitor
1000uF
1
5V Filter Capacitor
470uF
1
12V Decouple Capacitor
.33uF
1
5V Decouple Capacitor
.01uF
1
5V Regulator
LM7805
1
PNP Transistor
2N4403
11
10K Ohm Resistors
1/4W
11
220 Ohm Resistors
1/4W
3
100 Ohm Resistors
1/4W
2
Power On LED
Green LED
1
Heatsink
1.45” tall heatsink
2
Nut and Bolts
To assemble heatsink and regulator
2
Infrared Beam Transmit Unit
IR LED, two 7.5 ohm resistors 1/4 watt (wired in series to keep width small), small heat shrink to protect against shorting, red heat shrink to cover resistors and 10 inches of wire to make leads from.
2
Infrared Beam Detector Unit
IR Detector, one 47K ohm resistors 1/4 watt, small heat shrink to protect against shorting, blue heat shrink to cover resistors and 10 inches of wire to make leads from.
2
Beam Wire Crimps
Wire connectors to connect the send and receive portions of the beam to the wire running to the control unit.
10
Mounting Screws
Screws to mount control board.
4
Standoffs
Standoffs to keep control board away from mounting surface.
4
la placa seria la siguiente:
http://www.subirimagenes.com/otros-s...a-5193785.html
